Software
Firmware and software used to run a Voron 3D printer
On this page
Every official Voron runs Klipper. Klipper splits the work between a host computer (usually a Raspberry Pi or a small x86 board) that does the motion planning, and the printer’s mainboard, which just executes timed steps. That split is what allows the input shaping and pressure advance a Voron depends on.
Pages#
| Page | What it covers |
|---|---|
| Klipper | What Klipper is, how it is installed, and the web frontends that sit on top of it |
| Klipper Config Help | Working through printer.cfg, common errors, and where settings live |
| Klipper Macros | PRINT_START, PRINT_END, and other macros worth having |
Related#
- Motherboards — picking the board Klipper runs on
- Toolhead Boards — CAN and USB toolhead MCUs
- Bed Leveling — probe setup and mesh configuration